Page 1 of 1

Some problems, not bugs (i think)

Posted: Mon Apr 21, 2008 1:24 pm
by spirekin
while project is (programmed) polishing...
1. will be nice to see support of multiple users, for example:
when i start lightup' simulation(pushed at TourTool), it woks fine. But when i work at limited-user's settings(non-adminisrative...) and push TT, sketchup crashed(all features as AO, LST have normal feedback)
i work at windows xp sp2(32bit) and sketchup 6.4.112 (Pro)
-----
2. and sometimes whe i pushed AO ...it calculates several times and freezes(scene is lowpoly...// only need shutdown sketchup manually)

Re: Some problems, not bugs (i think)

Posted: Sat May 17, 2008 5:26 pm
by AdamB
spirekin wrote:while project is (programmed) polishing...
1. will be nice to see support of multiple users, for example:
when i start lightup' simulation(pushed at TourTool), it woks fine. But when i work at limited-user's settings(non-adminisrative...) and push TT, sketchup crashed(all features as AO, LST have normal feedback)
i work at windows xp sp2(32bit) and sketchup 6.4.112 (Pro)
I am unable to reproduce this behaviour. Can you give some more information about how to demonstrate this problem.

Thanks,
Adam

Re: Some problems, not bugs (i think)

Posted: Sat May 17, 2008 5:47 pm
by spirekin
Hello Adam! :)
1. i have 2 profiles: admin and guest in windows xp
2. Install(activate) lightUp in admin. i have normal work of LU.
3. Switch to guest(activate again)...then prepare scene with AO...when start LU simulation, sketchup had crashed(with bugsplat, but without any info; no messages in console)...i start sketchup again, but there aren't any notifications about recovery scene(and no bugsplat files in sketch dir)...
i get always shutdowns in guest...

Thanks for plug-in